Spares or repair - Runs up but metal work needs repair - PTO shaft present but seized - Gearbox ok - Hydraulic folding (some rust on ram) - Corrosion/holes on hood and skids - 2.4m wide

Used two years ago - Most tines present, odd one damaged - Surplus to requirements

Heavy duty set - Approx 2.4/2.5m working width - Good metal - Can be loaded for purchaser

C/w PTO shaft - Working - Tyres holding air with tread - 2-3 tines would benefit from replacement and odd spring - C/w hay gates, some bends to tines and have been welded on, needing re-welding/attaching in future (as pictured)

Working order - C/w small silo - 1m x 1m square x 2m high - Electrics will be disconnected - Telehandler available to load - Buyer to dismantle

Working when last used - 4'' auger - 240V

Working when last used - 4 1/2'' auger - 240V

Working when last used - 240V - Quantity of ducts

Unknown make - Working when last used - 240V - Quantity of ducting

Sliding table - 3 point linkage mounted - Very little use - Needs new PTO guard

PTO intact - Guard needs replacing - Working order - Requires a few tines - One clip on gate broken - Tyres holding air

Was working when last used at least 10 years ago - Single phase

3 point linkage mounted - Working order - Has a Fergi bar welded on to convert to CAT 2 linkage

Spares or repair - Has compression and turns over nicely - It did have a spark when playing around with it but the vendor has not seen it running - Starting handle has some damage to it

Working order - Would benefit with replacement brushes

Full of water

Spares or repair - C/w PTO shaft - Loading available - Gearbox and blades seem to be good - Top has rusted out - PTO needs a new guard

Spares or repairs - Most parts of a Lister JH Engine - No crankshaft - Piston and conrod are in the bore - Vendor has found some other bits for it not photographed - Magneto, starting handle and spec plate present

Approx 6' cut - Used last year - S/N: 288021 - PTO shaft - Has been used to cut 2 acres this year - Loading available

Year unknown - Serial No: 991B 393L - Bale count - 19282 - Wrapper size 750mm - Control box - Tidy wrapper - Hand controls - Never gone wrong - Will go straight to work - Only selling due to upgrade

SN: 00504 - Disc coulters - Not used for a few years, appears complete & in working order - Come with some spares

SN: 135983 - Not used for a few years, appears complete & in working order

In working order - C/w PTO but guard needs attention - Loading available - Skids need repairing

Spares or Repairs - Approx 2.43m cutting width - C/w PTO shaft - Loading available - No conditioner (still cuts fine) & doesn't stay in cutting position - Being sold as spares or repairs as it doesn't stay in its cutting position (possible something to do with the hydraulic breakaway) - Used this year but used a strap to keep in mowing position

Had very little use - Approx 1.8m/6' wide - Approx 2m/7' long - C/w towing chain

Working order - 8' wide - Sound body - Good skids - 3 position offset

Working order - Not used for 2 years - Barn stored

Tractor fencing strainer - Working order - Used condition

Always been dry stored since new

3 point linkage - Corn drill drives with a centre wheel which puts the corn out - Good condition - Always been dry stored

No welds - Always greased after use

Spares or repairs

Spares or repairs - Hydraulics all working fine but drums won't engage - Fairly clean and straight - Mower good breaker for parts

Good haybob with all tines present and straight - Spins up fine - Never been welded - Missing stand - Not been used for a few years

In good working order runs up fine - No rust holes, all solid - Good strong support straps - Solid A frame - 3 point linkage - Tops with no problems - Skids bent at front and cracked but still works fine

Spares or repairs

As shown in photos

Spares or repair - Serial No: 10509-0513 - 9' cutting width - C/w PTO shaft - Loading available - No grass conditioner - Suspected bearing gone in gearbox - Not been used for 4 years

Spares or repair - 25' manual folding boom - Fitted with foam marker - Machine not used for several years - Pumps turn over - Missing tractor end of PTO shaft

Spares or repair - Gearbox and tail turnover as should - Top plate missing - Crack in top of hopper

C/w Tong Conveyor & Walthambury automatic stitcher

Year unknown - PTO - Working order - Loading available onto trailer or similar

Working order - PTO - Loading available onto trailer or similar

Spares or repairs - 3 point linkage - Missing weight - No rock spike - Loading available onto trailer or similar

3point linkage - Flail/bush cutter - Cat 1 linkage, adjustable height - Approx 22'' cut - New condition

Used - C/w skimmers - Adjustable crossbar

1.95M working width - 2019 - Little use - Approx 360KG

Used - 2001 - 12V tested working - 3PT mounted (front or rear) - C/w cage tool box

For compact tractors - Used - Model W24TS-00334 - Little use & in good condition - Cost over £2400 new

Approx 6' long x 18'' round - iron can be removed if not wanted

Approx 5' 6'' long x 18'' round

Needs some light maintenance to it - some rust on rams

8' Lead roller & 2x 4' side rollers - - rollers are fine but framework needs some TLC

Spares or Repairs - Good gearbox - Good wheels & arms - Body is rotten - Ideal for parts

Spins up on the tractor, untested properly - A few tines missing

600L tank - No pump or pipes

Serial number unknown - C/w PTO shaft - Limited loading facilities - Does run up but vibrates a lot - Bolt on shaft is worn - Rear wheel is completely broken

Spares or repair - Year and model unknown - 2.4m working width - C/w PTO shaft but in complete - Loading available - Gear box is loose - Guard missing on side - One tyre is flat but does stay up for a couple of days - Missing flail

2.8m cutting width - Serial No: 8399 - Loading available - C/w PTO shaft - Does not have a grass conditioner - Spins up and cuts nice - Front and back rollers are adjustable - Rusty but solid

Tyres holding air - last used 3-4 years ago - string only - not used or ran up but parked up after last use, likely to need some attention/TLC - some corrosion and rust in places - Cannot be loaded onto lorry or similar

Spares or Repairs - Supa-Pac - 2 flat tyres - cables need attention - front box jack - 1 belt visibly damaged

Loading available - Has not been used for some years - Barn stored

Not been used for a long time

Spares or Repairs - Drum & lid solid - Chain seized

5 row precision drill, beet drill seed rollers being used currently. 4 turnip seed rollers also.

3 augers

Not been used in many years - 4 discs missing

Spares or repairs - Hydraulic shut off

Last used about 2 years ago - Size unknown - C/W splash plate - C/W pump (new vanes approx 3 years ago) - 1 tyre has soft puncture but will be pumped up

In frame (10' 8'' wide with frame) - Water filled (full at present) - Can be lifted on 3 point linkage - C/w additional weight frame on top - Clevis pin hitch

500 capacity - C/w PTO shaft - Lights & brakes untested - Used as water bowser - Not used for some years

With built in bucket - Working ok when last used but been sat around for a while - Water system has been disconnected

C/w discs - Very good condition - Good metalwork

Spares or repairs - Some parts missing having been parked up some years ago - Very much a spares only machine, no electric box

Spares or repairs - Has been parked up for many years - Tyres holding air - Lot of rot but some parts salvageable

Used until recently - good & straight - 5' 11''overall width

Tub in good condition - motor in working order - no brackets

Approx 9'' auger - not been used recently - has a lot of rust on auger - 3 point linkage mounted - needs new PTO cover

Spares or repairs - Tyres holding air apart from one with puncture - Hydraulic fold - Doesnt fold up - Hydraulic height adjustment - PTO shaft requires new cover - Some rust on metalwork - Not used recently

12V - Cable missing - MK5 model - S/N: 193213

Spares or repairs - 12V - Boom has some rust - One jet missing

Solid frame - On ring hitch

3 point linkage - PTO driven (needs new PTO cover) - Blade good - Belt conveyor length 4.4m long - Good working order - Wheel needs new tyre - S/N: 0834054J - Please note this lot is part of a genuine dispersal on behalf of a deceased estate. There will be a collection day held on Friday 3rd July between 9:00am to 5:00pm. There is a viewing day on Friday 26th June, between 9:00am to 5:00pm.

Spares or repairs - Cable control - Hydraulic block and cable controls damaged - Believed to have fallen over in storage - T flails - 1.1m head - Forward control - Please note this lot is part of a genuine dispersal on behalf of a deceased estate. There will be a collection day held on Friday 3rd July between 9:00am to 5:00pm. There is a viewing day on Friday 26th June, between 9:00am to 5:00pm, the sale address is Exeland Farm, Bickleigh, Tiverton, EX16 8RA.

Spares or repairs - Engine turns over - Barn stored - Please note this lot is part of a genuine dispersal on behalf of a deceased estate. There will be a collection day held on Friday 3rd July between 9:00am to 5:00pm. There is a viewing day on Friday 26th June, between 9:00am to 5:00pm, the sale address is Exeland Farm, Bickleigh, Tiverton, EX16 8RA.

Spares or repairs - C/W seat and box - Honda 5hp engine - Barn stored - Please note this lot is part of a genuine dispersal on behalf of a deceased estate. There will be a collection day held on Friday 3rd July between 9:00am to 5:00pm. There is a viewing day on Friday 26th June, between 9:00am to 5:00pm, the sale address is Exeland Farm, Bickleigh, Tiverton, EX16 8RA.

Some damage to rings - Straight drawbar - Please note this lot is part of a genuine dispersal on behalf of a deceased estate. There will be a collection day held on Friday 3rd July between 9:00am to 5:00pm. There is a viewing day on Friday 26th June, between 9:00am to 5:00pm, the sale address is Exeland Farm, Bickleigh, Tiverton, EX16 8RA.

30T pressure - Hydraulic loading arm and blade - PTO driven - 3 point linkage - Working order - Used last year - Very heavy duty - Please note this lot is part of a genuine dispersal on behalf of a deceased estate. There will be a collection day held on Friday 3rd July between 9:00am to 5:00pm. There is a viewing day on Friday 26th June, between 9:00am to 5:00pm.

Approx 42'' working width - Odd flail missing - Believed to be in working order - C/w rear roller - No age stamp

Working order - Comes with new belts - Has sliding table top to put the log onto the blade - Blade has all its teeth

PTO driven - No shaft - C/w homemade approx half ton hopper - Last used in 2025

4 Furrow - 7 slatted boards - Been sat outside

C/w PTO - Last used 12 months ago and worked well

Vendor has bought but never used it - Approx 1.1m Working width

Will spread grass seed or slug pellets - C/w ATV Fixing brackets - Manual shut off - Missing 1 plastic nut

9 Row - 4.4m overall width (non folding) - approx 4m working width - currently set on 20'' spacing - used this spring to do 50 acres - good working order - will need to go on a trailer to be moved

84kg - Spool Control - Reasonable Blade

Recently serviced - C/w long PTO Shaft - Used frequently and last used 3 weeks ago - Single phase - C/w 2 changeover switches & associated armored cable - Please note this lot is part of an ongoing dispersal with the vendor having relinquished the farm tenancy

Galvanised - Bought new on farm - 3 point linkage mounted - Hydraulic folding - Please note this lot is part of an ongoing dispersal with the vendor having relinquished the farm tenancy