Marked as 27 - Very tidy for age - Dry stored - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Marked as 28 - 7 tines - 3' 6'' wide approx - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Hydraulic - C/w Merlo brackets - C/w 2 sleeves & spikes - This lot is being sold as the vendor has changed farming policy & ceased keeping cattle

6' long when shut - This lot is being sold as the vendor has changed farming policy & ceased keeping cattle

2metres long - Aperture is 110MM x 50MM approx - This lot is being sold as the vendor has changed farming policy & ceased keeping cattle

Some bends on tines - Chilton brackets - Solid

Heavy duty set - Strong - Pin & cone brackets

Missing 1 bottom tine - Missing 1 top tine - Needs a hose replacing - Euro 8 bracket.

Age and brand unknown - Has wear on moving arm pins - Quicke No 3 - Will handle round or square bales - Well used and has repaired on the arm - Hoses are in poor condition but is useable

Hydraulic - Full swivel - Working - 28'' opening - Sale due to upgrade for bigger grab

Very strong - 1 Tine missing

Good solid squeeze with tubes & spikes - Does need new pipes - Has bolt on brackets so can be easily changed

Twin ram - Side tines - On MX brackets

This bale spike came off a front loader on a Fordson Major - Still solid & good condition

2.8T - Fits John Deere 20/30 series

C/w tool box

All with galvanised mesh - For lambing pens

No longer needed

Good condition - No longer used

Good condition - No longer required

No long required

C/w galvanised guillotine gate, 2 x galvanised hurdles and latching entrance gate - C/w 4 pins - Tray solid and holding water with mesh cover - Minor bend on top of guillotine gate and on 1 hurdle however does not effect use in any way - Approx 10' long x 3' 3'' wide

6 bars - Both generally straight - Both have a latch but no hangings - Collection for lots to take place after 23rd May 2025

4.2 meters long - Very heavy & well made (auctioneer could not put upright!) - Needs wooden trough & side to be put in - Generally straight - Collection for lots to take place after 23rd May 2025

C/w 2 weights - Collection for lots to take place after 23rd May 2025

C/w flow metres - Bought new on farm approx 6 years ago - Teats all present but may need renewing

Spares or repairs - Siezed

Spares or repairs - 100 litre tank - Not used for approx 20 years

Approx 9' long and 16'' width at top - Two have slight bends and one very bent - All good floors and useable

4' wide x 3' high (back) x 2' 1'' deep - Top lid is bent

9' long x 14'' wide - One has slight bend and good floor, one very bent with rusted floor

Fully galvanised - Free and working - Very tidy - Head clamp & body clamp - Foot pedal allows offset position - 1.9m long - Auto-locking

Adjustable access bars - Very good troughs - C/w transport wheels - Generally tidy order

Adjustable access bars - Very good troughs - C/w transport wheels - Generally tidy order

REMOVED DUE TO UNFORESEEN CIRCUMSTANCES

13'' Wide x 19'' high - All showing rust with some damage but all useable - This lot is part of a reduction sale, the vendor has ceased keeping livestock

Includes 2 new blade screws (no combs or blades) - C/w handpiece - C/w instruction book - In good condition - Used in 2024

Unit hardly used - Fully insulated - Good condition

Solid trough - Wheels present - Adjustable access

Good wheels - Adjustable access bars - Good trough

Working when last used, loose terminal - C/w wire and 4 stakes

Fully galvanised - Removable side rails - Treadplate floor - Hinged vet panels in each yoke leaf - Rear gate - Pallet fork lifting points - Everything straight and working as it should - Has had very little use on smallholding and only sold as no longer keeping cattle

Approx 5' - Some rust on bottom - Missing 2 bars but c/w all pins - Ring loop ends all present - Perfectly useable

Missing one Valve

Unused

Unused

Unused

Spare or Repairs - Useable feeder but lower rail rusted away one side & the other is rusted can be used as is or needs repair

3' diameter - 1 missing rail - Holding water.

Bars mis-shaped - Holding water - Approx 3' diameter.

Holds water.

Marked 1 - 1 with slight bend & 1 with 1 lug bent still useable

Marked 2 - Varying condition, some needing repair, some useable as they are

Marked 3 - Wooden - Some walk through, some feed fronts - Varying condition, some repairs needed - More than 5 but under estimated to allow for damaged - Buyer will need to load by hand with no assistance from vendor

Marked 5 - WM Ironworks - Race gate at one end needs attention

Marked 6 - Varying condition, some with bends/ missing lugs etc - Most have faults of one kind or another but would do a job

Marked 7 - Mostly straight & correct - 1 has a damaged lug, 1 has slight bend

Marked 8 - Varying condition - Some bends, missing lug etc

Marked 10 - WM Ironworks, galvanised - C/w 4 pins - Straight, correct & strong except for very minor bend on lugs

Marked 11 - 1 needs repair before use - 1 has bend on top rail but otherwise useable - C/w 2 pins

Marked 12 - Solid frame - C/w 1 pin

Marked 13 - Solid frame

Marked 14 - Slight bends on pin lugs & 2 lugs missing - Otherwise, straight & strong - C/w 1 pin

Marked 15 - Slight bends on lugs otherwise straight & strong - C/w 1 pin

Marked 16 - Solid framework - C/w 2 pins

Marked 17 - Smaller one useable as is, larger one needs handle re-welding on top operate - Solid framework - Galvanised

No holes

Marked 19 - Working - Odd spring would benefit from replacement - Solid framework

1 x 6' long - 3 x 3' long - No holes but varying condition

Marked 21 - Additional bottle rack - New teats needed

2 x small hook-over - 2 x large 6' wall-mounted - 1 large one is damaged/ mis-shaped

Creep access gates - Some missing rollers & remaining rollers have wood-worm - Solid framework

Marked 24 - Galvanised - All useable

Marked 25 - Varying condition

Marked 26 - 5 x JFC DT10 - 1 x Double sided drinker - 3 with ball-cocks, 3 without

Marked 27 - Lid present but not attached - 4 wheels - Trough present

Marked 28 - Trough mis-shaped in places but useable as it is - 4 wheels

Marked 29 - Complete - Trough sound (slight bend - 4 wheels

Marked 30 - Complete - Trough sound (slight bend - 4 wheels - C/w roof but not attached

Marked 31 - Complete - Good order - 4 wheels

Marked 32 - 7 sections - Hangers to connect - Unknown if complete or how it should be set-up but some useful bits

Marked 33 - 2m wide x 1.5m deep x 75cm high approx - Unplumbed - No assistance with loading

Marked 34 - Trough sound - Adjustable access bars - Bends on lid - 2 wheels

Marked 35 - Trough sound - Adjustable access bars - Bends on lid - 2 wheels

Feed trough was repaired 2 years ago - Used recently - Generally straight - C/w 3 point linkage and pallet fork attachments - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

2.5 metres long - No holes - Done little work - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

2.5 metres long - Approx 3 years old - Generally straight and sound trough - Marked A - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

2.5 metres long - Approx 3 years old - Generally straight and sound trough - Marked B - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

All bars straight - Missing bottom cross member - Pin holes on either side - Dung board bottom - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

Galvanised - All complete and good condition - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

Galvanised - Missing 4 tombstones - Good tin work - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

Galvanised - Only 2-3 years old - Good condition and complete - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock