Good tyres - Lights all work - Aluminium floor - 6 tie on eyes - C/w spare wheel & locking key - 6' 6'' wide - Brakes work

15' x 7' - C/w new spare wheel and tyre - Good tyres - C/w Beaver tail and rear ramp - C/w front lade and 2 small front 4' side panels - C/w winch - Brakes work but lights need attention - New boarded floor last year

Good tyres - C/w stabilisers - Plastic tank is approx 1.8m x 1.0m x 0.85m (c/w lid) - Right hitch - Tank is on a solid galvanised floor

Twin axle - Type- TA510G-12 - C/w sheep decks - Bought new on farm in 2001 - All new tyres last year - Brakes & lights work - C/w spare tyre (not pictured/no rim) - Only been used on a small holding

Trailer length, 16' 6'' - 8' wide - C/w rear & front lade - C/w Strap down ties - Timber floor in reasonable condition -

Lights present but not working - Steel chequer plate floor - Tyres have good tread not done much since new - 13' long x 6' wide - C/w loading ramps

Serial number: 406953 - Trailer length 12' - Lights present but not working - Brakes untested - C/w jockey wheel - Floor in good condition - Tyres holding air and in fair condition - Box on trailer has a hole in top - Just needs a bit of TLC otherwise not in bad condition

Trailer length 12' - Trailer bed length 6' 6'' - C/w loading ramps & rear legs - Caring capacity 3500kg - Lights present and working - Brakes and hand brake working - C/w spare wheel - C/w jockey wheel - Floor needs attention but in use currently - Used trailer, not new, some dents and scrapes, etc

Boarded floor - Brakes & lights work - GX126 - 12' x 6'

Mesh floor - 90'' long x 60'' wide - No brakes or lights - 2 good tyres

Solid chequer plate floor - 6' wide x 10' long approx - Removable sides - Solid chassis & drawbar - Single tipping ram - Tyres holding air - Believed to be approx 3-4t capcity - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Marked as 17 - Lights present but untested - Tyres are soft and will need pumping up or maybe replacing prior to collection - Chequer plate floor - C/w spare wheel & tyre - Very tidy for age - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

*Please note this trailer does not come with bale extension & lades as previously advertised* Marked as 18 - 1986 Foster Load-Master 6T Grain Trailer - 6' 6'' Wide x 11' long approx - Believed to be 6T capacity - C/w tailgate & grain door - Good floor for age & solid chassis - Removable sides - C/w silage sides & front & rear lades - 1 tyre very good, 1 tyre with tread, both holding air - C/w canvas cover - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Lights present but untested - SN: 5006 - 8Ton carrying capacity - Hydraulic brakes - Floor appears ok, some rust holes at front - Used and some perishing - Rusty metal work on tailgate tipping arms - Rusty metal around front mesh - Brakes fitted but no pipe - Does not come with grain door - C/w silage sides as seen in photos

Tri axle - 2015/2016 - SN: SCKT0000F0676941 - Lights working - Brakes working - C/w spare tyre - Cattle partition gate - Detachable livestock container - New tiers - Good clean, genuine trailer

Standard grain door - Floor in tac condition (shown in photos) - Tyres holding air - Grain trailer with wooden floor & sides - Always been barn stored - Last held grain a couple of years ago - Trailer hydraulics are in working order

Been used to take quad bike - Boarded floor - Ramp need repairing - Good tyres - Lights work (LED lights) - Approx 2.0M long x 1.2M wide - This lot is part of a syndicate shoot dispersal

Single axle - Needs attention inside - Spares or repairs - This lot is part of a syndicate shoot dispersal

2021 - S range - Good tyres 10.0/75-5.3 - Good solid floor - C/w dropsides (detachable) - Trailer is 3M x 1.8M - Bought new on farm - This lot is being sold as part of a change in farming policy, having been purchased and used on a Blueberry Farm

C/w toilet, store cupboard, rest room area and electrical hook up - Approx 4.3M long x 2.0M wide x 2.4M high - Restroom has seating, sink and heater - Trailer has been parked for approx 2 year - Brakes and lights were working when parked up - This lot is being sold as part of a change in farming policy, having been purchased and used on a Blueberry Farm

C/w spare wheel and tyre - Twin axle - C/w cattle partition gate - Drainage tank - Lights present -

4 tyres with tread/holding air - No decks or partition gates - C/w jockey wheel - 10' long x 5' 6'' wide - Brakes need adjusting - Lights present and believed working - Wooden tailgates

Standard bracket type - Two side spikes have been lost/removed

A frame/ 3 point linkage

C/w Euro Brackets - Bought new last year - Made by J Bourne Tractors - Bought new on farm - C/w own stands - Used last year - Well made - This lot is only being sold as the vendor has ill health

Other linkage support is available - Spares or repairs

C/w ball hitch attachment - 3 point linkage - well made - no loading available.

''This lot is only being sold as the vendor is giving up contracting.''

19'' Wide - 5'' between top pins & 4'' between bottom pins - Collection for lots to take place after 23rd May 2025

5 are the same (11'' wide) & 1 different (also 11'' wide at the top) - Collection for lots to take place after 23rd May 2025

19'' & 9'' Wide - Both have 4'' width between all pins - Trenching bucket (9'') is missing teeth - Collection for lots to take place after 23rd May 2025

Working order - Surface rust on scoop - Underside of fork slot will need attention - 4' wide x 3' deep x 18'' high

3 pnt linkage - Concrete filled metal barrel

3 point linkage - 27'' wide x 34'' high - This lot is part of a reduction sale, the vendor has ceased keeping livestock

This lot is part of a reduction sale, the vendor has ceased keeping livestock

C/w controls and subframe

Grays bracket - Good working condition

Euro brackets

Euro 8 bracket - 4' 6'' - Extension bolted on the sides - Metal work in good condition, no holes or much rust

Strong and correct - Loading only available within 5 days of the sale closing as telehandler is being sold

4 tines (some movement) - Very strong, well built frame - JCB Q-fit brackets - Loading only available within 5 days of the sale closing as Telehandler is being sold

Strong and well built - 2 smalls cracks in base of bucket as pictured, other than that very solid - Reasonable wearing edge - JCB Q-fit brackets - Loading available within 5 days of the sale closing as telehandler is being sold

Spares or repairs - Some holes and splits that need plating/repair - JCB Q-fit brackets - Could be repaired - Loading only available within 5 days of auction closing as telehandler is being sold

Euro 8 brackets - All tines present and straight - Working order

Pallets are 1 metre long - 1.2 metres wide x 1.3 metres high - Well made

30'' width

Three point linkage

45mm diameter pin holes - 170mm pin width - 230mm pin centre to pin centre - Fits Takeuchi & similar 4-6 tonne excavators

45mm pins - 152mm pin width - 240mm pin centre to pin centre - Fits Takeuchi and similar 4-6 tonne excavators.

1100 heal to end - To fit on a 400mm carage

New Holland to Manitou head stock adaptor plate - You could easily cut the New Holland connector and replace it with a different connector

2 meters long

2 meters long

2 meters long

Marked 4 - C/w bag lifting hook - Pin & cone conversion frame - No loading assistance provided by owner

Marked 9 - Spares or Repairs as not used in recent years - Tines grown in and not visible - Clean rams - Pipes present but perished

Marked 37 - Some corrosion - Not used recently - No loading assistance available, buyer will need to - Pin & cone brackets - Rams clean - Tines cannot be seen (grown in)

Euro brackets - One sleeve does not roll as has been welded on - C/w top bar - Used last year - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

Square or round bales - Euro brackets - 3 spikes - This lot is part of a genuine dispersal sale. The vendor having ceased keeping livestock

Manual tip - Solid floor - 3 point linkage mounted - Removable tailgate

All tines present and correct - Pipes present - Solid frame with some re-enforcing

Euro 8 brackets - Unused - Solid tines & framework - Pipes all present

Approx 20-25kg each - C/w all bolts

23.5'' diameter - 6 x weights - Bolt hole centre diameter approx 22.5''

2 tines - Solid Frame

Loader boom and 2.6m bucket - Euro headstock - Self levelling - No mounting brackets

Came off MX 100 loader - All straight

Euro bracket - Has had new floor fitted in the last 6 months

1700mm x 900mm x 430mm - Old but dry stored, tipping action working, surface rust only - One board in base cracked but useable

Euro brackets - Browns S/N BL 26459 - Euro brackets - Working fine when last used in 2023 -

100CM - Rear scoop for compact tractor - Tips - Good condition - 1M wide

Spares or repairs - Hydraulic headstock - Was all working when last used but been sat for a year or so

30 years old - Fits Quicke Loader (not euro brackets)

Euro 8 bracket - Square and round bale handler - Opens to 7' wide - Bolt on brackets

Specially made extra heavy grading bucket - 60mm pins - Head treated cutting edge - Wear bar on bottom

8/9T size machine - 60mm coupling

200mm rear roller - No head stock or power tilt included - for a 8-13T machine

For 8-13T machine - Bolt on power tilt head - 45 degree tilt each way - No digger head or grading beam included

Good grab on euro 8 brackets - Open and closed with no issues - Outside tines have some play but do not affect use

Good solid bucket, tips with no issues - Has had one new pipe fitted week ago - Solid frame ready to have own brackets put on

Good solid and strong

On euro 8 brackets - In working order

Age unknown - Chilton brackets - Good working order, will go straight to work

On chilton brackets - Pipes do not leak but do have perishing - Solid spike but one has a slight bend in it

Trima brackets

Blue

Early Euro brackets - Hydraulic pipes perished - 1 rust spot on ram

Set of 8 Massey Ferguson tractor weights - 40kg each with some fixings - One is missing an upper front piece

C/w John Deere top link bracket - 3 point linkage

3 point linkage - 3 spikes

2.5m long - Aperture 140mm x 80mm - Solid & straight

Marked as 7 - Single ram - Solid framework - All tines present - Some rust on ram - Dry stored until sale preparations - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Marked as 11 - Solid framework - Pipes perished - Bolt-on brackets - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Marked as 14 - In use on MF 148 until recently - Some small holes in bucket but still functional - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Marked as 23 - 10 tines (1 missing) - Solid framework - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Marked as 24 - 3pnt linkage - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.

Marked as 25 - This lot is part of a genuine unreserved dispersal sale on behalf of the executors of the late Mr L Spiller. A viewing day where all lots will be available to view will be held between 10am - 4pm on Friday 16th May. A collection day where all lots should be collected and a telehandler will be on-site to assist with loading will be held on Friday 23rd May.