Working order but needs to be re-lined on rear right hand side

Trailed Teagle Tomahawk Straw Chopper - Lights working - Swivel shute - Remote control/bluetooth controls with everything working as it should - Tyres in very good condition - One previous owner - Had little work over last 3 years - Straight PTO - C/w manual

All in working order - Tyres like new - Rollers are full but can be emptied - Has filling bungs - Loading available

C/w additive pump and mineral hopper - High output machine - Good working order - C/w PTO shaft - Lights working - Mechanical loading available - Maximum lorry size access available

Serial No: 025995 - C/w control box - Adjustable rate - Wheel eradicators - Hydraulic packer adjustment - Pre emergence markers - Following harrows - Low level tank sensor - 1000RPM gearbox - Always barn stored - Sprayed with oil each year - Bout markers - Lots of metal left on Kverneland tines - C/w operator book (as pictured) - Has some spares - Lights and PTO working - Vendor owned for over 20 years - Loading available

Unused and like new - Serial No: 2404102 - C/w extras in the form of calibration hopper and 1 outlet rotor meter 5mm seed roller kit (for fine seed) - C/w control box

Serial No: EUII1460C4637 - 14 cubic meters capacity - C/w PTO shaft - Lights untested - Working electric weigh display - Blades are well worn, no holes in auger - Tyres worn and may need attention before driving away however holding air - Mixes pit silage well, ability to feed out both sides, original condition - The right hand elevator needs a new motor and possibly a belt

Conventional baler - Serial no. 3937 - C/w PTO shaft - No control box - Baled 1500 bales, rarely missed a knot - Mechanical loading available - Maximum 45' lorry access available.

Conventional baler - C/w PTO shaft - Serial No. 3836 - Fully serviced & knotters fully serviced - Recent invoice to prove this work - Good working baler - Mechanical loading available - Maximum 45' lorry access available.

Tyres holding air - One owner from new - C/w PTO shaft - All tines present - C/w prop - Previous weld repair on one pivot as pictured but still functions - Hydraulic folding - One pin need re-lining/bushing and pictured